ATI: Robotic Tool Changers Discrete Modules SC29 Tool Side 9121-SC29-T

The module is designed to provide control of the Tool Changer, pass electrical power and signal connections to a servo motor, and pass Ethernet field bus data to the end‑of‑arm tooling. Power and signal circuits are electrically isolated both from each other and the Tool Changer. The wiring has EMI/RF shielding to protect it from noise.

Product Advantages

• The module is designed to provide control of the Tool Changer, pass electrical power and signal connections to a servo motor, and pass Ethernet field bus data to the end-of-arm tooling.
• SC29 Master has: (1) Harting 10B connector (8-Pin power insert, 25-Pin signal insert, and 12-Pin I/O insert), (1) 3-Pin M8 female valve connector, (1) 4-Pin M12 D-Coded female Ethernet connector.
• The SC29 Master is designed to mate with either the SC29 or SC30 Tool modules.
• SC29 Tool has: (1) Harting 10B connector (8-Pin power insert, 25-Pin signal insert, and 12-Pin I/O insert), (1) 4-Pin M12 D-Coded female Ethernet connector, and (1) 4-Pin M12 female TSI connector.
• SC30 Tool has: (1) 4-Pin M12 D-Coded female Ethernet connector, (1) 5-Pin Minifast female auxiliary power connector, and (1) 4-Pin M12 female TSI connector.
• The SC29 and SC30 Tool modules support 0-9 Tool-ID.
• Supports double-solenoid integrated valve (single-solenoid valve is not supported).
• Supports L/U/R1/R2 sensors.
• The SC29 and SC30 Tool modules support TSI on the Tool with no RTL bypass.
• Spring-loaded pin block allows the Master and Tool modules to communicate across their interface when coupled.
• A flexible pin boot surrounds the pin block to seal the connection from moisture and liquid while coupled.

9121-SC29-T - Harting Module, Supports Servo Power and Supports Servo Power and Redundant Encoder and Ethernet Signals, 0-9 Tool-ID, TSI on Tool - Tool side