Single Axis control

Ultra High Speed

Super fast pulse output possible. Maximum 7.25 MHz (when the input reference clock is 14.5 MHz)

Speed and acceleration/deceleration slope can be changed during pulse output

Accelerating/decelerating gradient individually set

Various error interrupt input terminals

2 terminals: General purpose input/output

16-segment micro-step data output for 2-phase stepping motor (D/A conversion)

Trapezoidal and triangular drive

Calculation function: Deceleration starting point automatic

Overrun stop: Forward/Reverse

Slow down stop

Immediate emergency stop

Pulse output completion control by servo setup signal

Emergency stop by servo deviation counter overflow

Read output pulse number

Setting by acceleration/deceleration speed

Excitation direction output

6-bit data output for micro step

Power-supply voltage: TTL level 4.75 to 5.25 V

Reference clock: 131 kHz to 14.5 MHz

Total pulse number setting range: 1 to 16,777,216 pulses

Deceleration start point setting range: 0 to 16,777,215 pulses

Number of frequency setting steps: 65,535 steps

Acceleration deceleration tilt setting step number: 65,535 steps

Basic clock division step number: 256 steps

2 terminals: General purpose input terminal

Pulse output: 1/2 pulse switching

～ 255.8555Hz 0.0039 (CLK = 131KHz, N = 0 [= 256])

1 ～ 65,535Hz (CLK = 3.2768MHz, N = 25)

110.63 ～ 7,249,889.37Hz (CLK = 14.5MHz, N = 1)

～ 255.7149Hz 0.0039 / Sec (CLK = 131KHz, N = 0 [= 256])

25 ～ 1,638,375Hz / Sec (CLK = 3.2768MHz, N = 25)

12.238 ～ 802.028MHz (CLK = 14.5MHz, N = 1)

252 mW (Max) when input reference clock is 14 MHz

154 mW (Max) when input reference clock is 6 MHz