SIMATIC DP, electronic module for ET 200SP, 6ES7136-6BA01-0CA0
The SIMATIC ET 200SPI/O system is a highly flexible, modular I/O system with IP20 protection.it can exchange IO data of the connected I/O modules with a higher-level control system.ET200SP components are available as SIPLUS version for extreme requirements and high degree of robustness. Via an interface module with PRODINET or PROFIBUS interface it can exchange IO data of the connected I/O modules with higher-level control system.
SIMATIC DP F-DI 8x 24VDC HF Digital input module for ET 200SP,PL in accordance with ISO13849-1: PL e, SIL in accordance with IEC 61508: SIL 3
Safe digital inputs: 8,Supply voltage: 24 V DC,Input type 1 (IEC 61131),Module diagnosis: Power supply,Input delay 0.04–20 ms, Suitable for BU type A0
The module has the following technical properties:
• Fail-safe digital module
• PROFIsafe & RIOforFA-Safety
• PROFIsafe address type 2
• 8 inputs (SIL3/Cat.3/PLd) or 4 inputs (SIL3/Cat.4/PLe)
• 8 outputs for sensor supply
• Use of various interconnection types (1oo1, 1oo2) is possible
• Safety mat evaluation (firmware V2.0.0 or higher)
• Supply voltage L+ & Sink input (P-reading)
• Suitable for the connection of 3-/4-wire sensors according to IEC 61131, Type 1
• Suitable for the connection of 4-wire safety mats and pressure-sensitive protective devices (NO contact operating principle) according to ISO 13856-1, -2, -3
• Channel-specific assignable input delay 0.4 ms to 20 ms
• Internal short-circuit-proof sensor supplies for each input
• External sensor supply possible
• Diagnostic display (DIAG red/green LED)
• Status display for each input (green LED)
• Error display for each input (red LED)
• Diagnostics – e.g. short-circuit, channel-based – e.g. load voltage missing, module-based
• Channel-based or module-based passivation The module supports the following functions: • Firmware update, I&M identification data & Service data WARNING